Extendable loading floor: Calidrawer JALOPY 710mm

Calidrawer JALOPY
Pull-out LOAD FLOOR for all California variants with factory-installed cabinet by Volkswagen.
T5.1 Comfortline and Trendline - T5.2 California Comfortline, T6 California Ocean and Coast, T6.1 * California Ocean and Coast
Also for T6.1 Beach with 2-seater sofa bed and storage space on the side.
Note for the T6.1 California Ocean and Coast:

Available versions : 710mm / 760mm / 810mm

The seat in the T6.1 is positioned differently due to the lounge function!
The bench is now 5 cm further back. So if you want, you have more room in the front.
Everyone is of course free to put the bank back as it was in T5 and T6. Then the 760 fits again. And a little further forward also the 810.

But if you want to take advantage of the extra space in the passenger compartment, you can also find it in the future.
For the T6.1 one We are currently developing a shorter version for the new standard position in the T6.1. The Jalopy 710!

However, if you continue to pay attention to the storage space in the back, you can still install a Jalopy 810 if you push the sofa a hand further forward accordingly.

Substructure made of CNC-welded aluminum corners, surface ground (supplied with protective film)

The aluminum shell of 3 mm thick material - surface aluminum silver natural - with protective film on both sides. The corners have been sanded clean.

Simple, light and screwless attachment to the rail system of the T5 / T6 / T6.1. The attachment is done with original Volkswagen locks.

It doesn't matter if two or three floor rails are installed. The third (middle rail) is not relevant for mounting. Only the two outer rails are used as with the seat.

Very robust heavy-duty rails lock in and out automatically.

Aluminum fairing 80 mm on three sides and 40 mm edges on the operating edge.

The 760mm version fits standard in the vehicle with the rear seats. When choosing the 810 mm version, the rear seat should be moved 2-3 cm further into the passenger compartment. For this, the 810 version can carry two Euro boxes with a depth of 400 mm in succession.

A black fleece mat is placed in the bath. It has a pleasant, soft surface that is easy to vacuum.

The back is covered with rubber granulate and thus serves for slip resistance.

The overall dimensions of the entire loading floor are approximately 1000 x 825 mm for the 760 mm deep version and 1000 x 865 mm for the 81 0mm version

Carpets attached to the side of the cabinet do not disturb.

Weight: 18.5 kg

There is a 6mm plate above the rail. Then there is 10 mm space for the drawer and the drawer itself with 3 mm. So no more space is lost such as 19 mm. No longer like the bottom of a normal box.

The pull-out back is available in two sizes. The difference is only a few centimeters. But the 810 version can hold 2 Euroboxes in a row, but is about 20-30mm further in the passenger compartment. So it cannot be pushed all the way down to 2-3 cm.

The extendable rear wall is very stable and can be loaded with 100 kg with an even distribution in the aluminum container. The heavy-duty rails are designed up to 250 kg.

With an additional attachment (slid under the cupboard), the pull-out cupboard can also be loaded up to 150 kg.

A dimensional explanation of the dimensions of the pull-out rear wall in the table below: